So a few days ago I thought I was almost ready to finish painting, start laying floor, and get the faucets hooked back up from the countertop installations.
Until I pulled the fold-out table away from the wall to remove it until I could take the time to repair it. And found a wet, rotten place on the floor hidden beside the front gaucho. I'm still working on figuring out where it's coming from, but for now I just need to be able to get to it.
I've removed the gaucho and the shelves that sat over and beside it, but I need to remove the fresh water tank to remove the section of subfloor. What are the steps to this? It seems to have two pipes going in from the front of the trailer, and one going down through the floor, but I haven't had any luck disconnecting any of those. Is there a trick I'm missing?
Also, when I take it out, I can tell that it has some water sitting in the bottom of it... presumably incredibly nasty water. Should I shop-vac it out and do the bleach treatment I've read about? Or just look to replace?
I didn't get a chance to take pictures of the pipe connections before I came in to wash the nasty insulation off my hands, but I can try to post them tomorrow if need be. Thanks in advance from an Argosy newb! :)
Until I pulled the fold-out table away from the wall to remove it until I could take the time to repair it. And found a wet, rotten place on the floor hidden beside the front gaucho. I'm still working on figuring out where it's coming from, but for now I just need to be able to get to it.
I've removed the gaucho and the shelves that sat over and beside it, but I need to remove the fresh water tank to remove the section of subfloor. What are the steps to this? It seems to have two pipes going in from the front of the trailer, and one going down through the floor, but I haven't had any luck disconnecting any of those. Is there a trick I'm missing?
Also, when I take it out, I can tell that it has some water sitting in the bottom of it... presumably incredibly nasty water. Should I shop-vac it out and do the bleach treatment I've read about? Or just look to replace?
I didn't get a chance to take pictures of the pipe connections before I came in to wash the nasty insulation off my hands, but I can try to post them tomorrow if need be. Thanks in advance from an Argosy newb! :)
0 commentaires:
Enregistrer un commentaire