The past 4-5 trips I fill the fresh water tank prior to taking off. I fill it until it starts to run out the vent hole.
Inside the monitor says it's full.
Once I get to my destination it's, at least, half gone. I believe the monitor to be accurate as the water we use (i.e. what's available) goes fast and empties--meaning very little water is in the tank.
When the trailer is sitting, before, during or after the trip, there is zero evidence of leaks.
Thus, it must be losing water during the trip. I can see where some may splash out of the vent hole when it's full, but that can't account for 1/2 my water being gone upon arrival.
I have not removed the fresh water plate (4 screws) as it's sealed in place and am not sure that would accomplish anything or not. Obviously being sealed in place does not mean it cannot be removed, I just don't want to do it if it's a waste of time.
Any ideas?
Inside the monitor says it's full.
Once I get to my destination it's, at least, half gone. I believe the monitor to be accurate as the water we use (i.e. what's available) goes fast and empties--meaning very little water is in the tank.
When the trailer is sitting, before, during or after the trip, there is zero evidence of leaks.
Thus, it must be losing water during the trip. I can see where some may splash out of the vent hole when it's full, but that can't account for 1/2 my water being gone upon arrival.
I have not removed the fresh water plate (4 screws) as it's sealed in place and am not sure that would accomplish anything or not. Obviously being sealed in place does not mean it cannot be removed, I just don't want to do it if it's a waste of time.
Any ideas?
0 commentaires:
Enregistrer un commentaire