New problem: Inconsistent behavior

My setup: I play through six parallel chains into six low wattage amps. Each chain is a track in Mobius (Tracks 1-6, all sync'd to Default), Track 7 is recording a djembe and Tracks 8-10 are again the 6 parallel chains with sync set to none. I am using a Roland Octatrack on Windows 8.1 on a Clevo p750dm with 16gb memory, an i7-6700k and ssd hard drives.

Default sync is set to Out and I use LoopBe1 to sync Ableton Live 9.6 for drums.

Group A is Tracks 1, 3, 5
Group B is Tracks 2, 4, 6
Group C is Tracks 8, 9, 10

I use Group C to loop ambient interludes between songs. Groups A and B are for the actual songs.

The following script (yes, it is the same script I've posted elsewhere) works well for one button operation of Mobius EXCEPT when I have looped material on Group C (the unsynced group). Then the script does not usually want to work on any of Tracks 1-6 or Groups A or B (sometimes it will and sometimes it won't).

Code:

---

!name TheTap
!sustain 1000
!multiclick 200


if mode == reset
        Record
        end

else if mode == record
        Overdub
        end

else if mode == overdub
        Play
        end

else if mode == play
        Overdub
        end

else if mode == mute
        Play
        endif

Label sustain
        if sustainCount == 1
        Reset
        endif

Label click
        if clickCount == 1
        Mute
        endif

---

Why would unsynced tracks looping first cause this script to not work half the time?